Automated Device Enrollment

Be sure to complete the steps in the Configuring Automated Device Enrollment section of this guide. Also, verify that the device is assigned to Securly MDM in Apple School Manager.

To begin the enrollment process:

1. Power on your device.

2. The setup process will begin. Assistant panes will be skipped unless they were selected when configuring Automated Device Enrollment in Securly MDM. Additional setup steps may also be displayed based on the your selection in this same section. The only necessary step is to connect the device to Wi-Fi. Doing so will automatically contact ASM to check to see if it should enroll into an MDM and then download the enrollment profile. During the process you should see notifications on the device similar to:

   [Your District/Organization Name] will automatically configure your iPad.
   followed by
   Installing Configuration from [Your District/Organization Name].

   If you do not see these notifications, and instead see all the normal Setup Assistant questions, it means that the device did not receive the enrollment profile from ASM. If the device assignment was recently made, you may need to wait a bit longer before enrolling.

3. At this point, the Securly MDM profile will be installed and any profile restrictions you have configured in the Restrictions Profiles and assigned to the device group into which you are enrolling devices will be applied. See the Restriction Profiles section of this guide for more information.